| Premier Batteries | Leading the way in providing the best battery for your application | Chipping Norton - NSW Australia | |
  |
|
|
| |
|
< Back to SLA Batteries List
Sealed Lead Acid Batteries
Terminals, Charging & Application Notes
| TERMINAL INFORMATION |
|
| CHARGING |
Cycle Applications:
Limit initial current to 0.30C (C is the nominal A.H. capacity of the battery). Charge until battery voltage (under charge) reaches 2.45 volts per cell at 68 degrees F (20 degrees C). Hold at 2.45 volts per cell until current drops to approximately 0.01C amperes. Battery is fully charged under these conditions, and charger should be disconnected or switched to "float" voltage.
"Float" or "Standy-by" Service:
Hold battery across constant voltage source of 2.25 to 2.30 volts per cell continuously. When held at this voltage, the battery will seek its own current level and maintain itself in a fully charged condition.
|
| APPLICATION NOTES |
Continuous over or undercharging is the single worst enemy of a lead-acid battery. Caution should be exercised to insure that the charger is disconnected after cycle charging, or that the float voltage is set correctly.
Because there is a chance of off-gassing dydrogen and oxygen if the battery is overcharged, it is important to provide adequate air circulation.
Batteries should not be stored in a discharged state (or in a hot place). If a battery has been discharged for some time it may not readily take a charge. To over-come this, leave the charger connected and the battery will eventually begin to accept a charge.
Due to the self-discharge characteristics of this type of battery, it is imperative that they be charged after 6 months of storage at 20-25 degrees C, otherwise permanent loss of capacity might occur as a result of sulfation. To prolong shelf life without charging, store batteries at 50 degrees F (10 degrees C) or less. |
|
|
| |
|
|
|
| |
|
|
|
~ PREMIER BATTERIES PTY LTD, NSW AUSTRALIA ~
We supply all types of batteries including Alkaline Batteries, Barcode Scanner Batteries Battery Cases, Camera and Camcorder Batterires,
Battery Chargers, Battery Analysers, Laptop and PDA Batteries, Lithium Ion Batteries, Rechargeable Lithium Ion Batteries,
Lithium Ion Battery Protection Modules, Medical Batteries, NiCAD Batteries, NiMH Batteries,
Consumer Batteries, Industrial Batteries, Custom Manufacture, Polyswitches, Temperature Switches, Power Tool Batteries,
Sealed Lead Acid Batteries, Two Way Radio Batteries, Two Way Radio Intrinsically Safe Batteries
BATTERIES FOR ALL YOUR NEEDS
~ Australia and World Wide ~
Chipping Norton (Sydney area) New South Wales, Australia
